The innoFADER has been built from the ground up to utilise a new form of non-contact technology - capacitance. For you, this means installing and forgetting about it, rather than constant faceplate removing sessions to remove the build up of daily DJ dirt. That's not all - the innoFADER has a whole arsenal of adjustments as well as an almost universal plug and play architecture, making it the most user-friendly fader in the DJ scene. The success of a mixer is largely down to the feel of the crossfader. It's a highly personal experience that is often ignored with stock faders. You need to make it your own and feel that the fader won't break in your hands. The innoFADER comes complete with a solid steel 8mm fader stem, designed to withstand even that hardest battering from a heavy-handed scratch DJ. But thanks to specially designed polished Steel rails, the innoFADER runs as smooth as butter, responding to even the lightest touch. But that's not all - if you prefer a little more resistance from your fader, the innoFADER has a special tension adjust control. It's also been designed so that the tension adjust screw stays in place - no working its way free inside your fader. Right out of the box the innoFADER should fit into your mixer. But not all mixers are created equally, and the chances are you'll need to break out wire cutters and a soldering iron to fit your new fader. Not so with the innoFADER. We've come up with a simple plug and play circuit board that means you should be able to fit the innoFADER across the broadest range of mixers without modification. And just to safeguard you even more, we've included a test circuit just to make sure you're fitting the innoFADER safely.